TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 622 of 1434
TM 9-2320-366-34-2 10-56 Change 2 10-8. REAR AXLE DIFFERENTIAL PINION SEAL, YOKE SEAL AND DRIVE YOKE REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-366-10-1). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Puller Kit, Mechanical (Item 51, Appendix B) Wrench Set, Socket, (Item 84, Appendix B) Multiplier, Torque Wrench (Item 42, Appendix B) Goggles, Industrial (Item 28, Appendix B) Hammer, Soft Head (Item 33, Appendix B) Socket Set, Impact (Item 58, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B) Socket, Socket Wrench (Item 69, Appendix B) (TM 9-2350-366-20) Tools and Special Tools (Cont) Sling, Cargo (Item 56, Appendix B) Driver, Front and Rear Differential Yoke Seal (Item 54, Appendix D) Driver, Differential Pinion Seal (Item 51, Appendix D) Holding Bar, Pinion (TM 9-2320-366-20) Materials/Parts Sealing compound (Item 76.3, Appendix C) Seal, Plain Encase (Item 386.1, Appendix F) Screw, Cap (4) (Item 366.1, Appendix F) Nut, Self-Locking (Item 193, Appendix F) Personnel Required (2) a. Removal. (1) Lift tabs form two bearing cups (1). (1.1) Remove four screws (2) and two bearing cups (1) from drive yoke (3). Discard screws. (2) Push in on propeller shaft (4) to separate universal joint (5) from drive yoke (3). (3) Attach propeller shaft (4) to frame (6). WARNING Wear appropriate eye protection when working under vehicle due the possibility of falling debris. Failure to comply may result in injury to personnel. NOTE Step (3) requires the aid of an assistant. NOTE There are two types of bearing cups, those with tabs and those without. Perform the following step on bearing cups with tabs.