TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 610 of 1434
TM 9-2320-366-34-2 10-7. REAR AXLE ASSEMBLY REPLACEMENT (CONT) NOTE Left and right side lower shock absorber mounts are installed the same way. Right side shown. (13) Install pin (13) on rear axle assembly (2). (14) Position lower shock absorber mount (14) on rear axle assembly (2) with four washers (15) and bolts (16). (15) Tighten four bolts (15) to 284-343 lb-ft (385-465 N·m). (16) Perform steps (13) through (15) on left side lower shock absorber mount. (17) Remove transmission/differential lift from under vehicle. WARNING Adhesive Sealant MIL-S-46163 can damage your eyes. Wear safety goggles when using; avoid contact with eyes. If sealant contacts eyes, flush eyes with water and get immediate medical attention. Failure to comply may result in injury to personnel. (18) Apply sealing compound to threads of 45-degree fitting (17). (19) Install 45-degree fitting (17) in rear axle assembly (2). (20) Install rear axle breather hose (18) on 45-degree fitting (17). 10-48