TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 608 of 1434
TM 9-2320-366-34-2 10-7. REAR AXLE ASSEMBLY REPLACEMENT (CONT) b. Installation. NOTE Left and right side spring mounts and brackets are installed the same way. Right side shown. (1) Install bracket (1) on rear axle assembly (2) with two bolts (3) and self-locking nuts (3.1). (2) Tighten self-locking nuts (3.1) to 22-26 lb-ft (29-35 N·m). (3) Install pin (3.2) in rear axle assembly (2). (4) Position spring mount (3.3) on rear axle assembly (2) and pin (1). (5) Perform steps (1) through (4) on left side spring mount and bracket. WARNING Rear axle assembly weighs approximately must 1580 lbs (717 kgs). Rear axle assembly must be supported on a transmission/differential lift during installation. Failure to comply may result in injury to personnel or damage to equipment. (5.1) Position transmission/differential lift under rear axle assembly (2). (5.2) Install transmission/differential lift to rear axle assembly (2) with chain. NOTE Step (5.3) requires the aid of two assistants. (5.3) Install rear axle assembly (2) under vehicle. 10-46 Change 1