TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download

Page 599 of 1434

TM 9-2320-366-34-2 Change 2 10-37 10-7. REAR AXLE ASSEMBLY REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Rear stabilizer disconnected from rear axle assembly (TM 9-2320-366-20-4). Rear wheels removed (TM 9-2320-366-10-2). Air tanks drained (TM 9-2320-366-10-1). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Lift, Transmission/Differential (Item 39, Appendix B) Jack, Leveling Support, Vehicle (TM 9-2320- 366-20) Jack, Dolly Type, Hydraulic (Item 37, Appendix B) Wrench, Torque, 0-600 lb-ft (Item 97, Appendix B) Trestle, Motor Vehicle Maintenance (2) (Item 81, Appendix B) Multiplier, Torque Wrench (Item 42, Appendix B) Tools and Special Tools (Cont) Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B) Wrench Set, Socket (Item 84, Appendix B) Goggles, Industrial (Item 28, Appendix B) Wrench Set, Crowfoot, Ratcheting (TM 9-2320-366-20) Sling, Cargo (2) (Item 56, Appendix B) Hammer, Hand, Soft Head (Item 33, Appendix B) Materials/Parts Dispenser, Pressure Sensitive Adhesive Tape (Item 30, Appendix C) Sealing Compound (Item 75, Appendix C) Sealing Compound (Item 69, Appendix C) Screw, Cap (8) (Item 366.1, Appendix F) Nut, Self-locking (4) (Item 214.1, Appendix F) Personnel Required (3) a. Removal. (1) Place trestles under rear of vehicle. (2) Lift tabs from two bearing cups (1) (2.1) Remove four screws (2) and two bearing cups (2) from drive yoke (3). Discard screws. (3) Slide drive shaft (4) from side to side and separate universal joint (5) from drive yoke (3). (4) Attach drive shaft (4) to frame (6). WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. NOTE Steps (2) through (4) require the aid of an assistant. There are two types of bearing cups, those with tabs and those without. Perform the following step on bearing cups with tabs.