TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download

Page 595 of 1434

TM 9-2320-366-34-2 Change 2 10-34.5/(10-34.6 Blank) (11) Remove drive shaft (16) from frame (17). (12) Position universal joint (18) on drive yoke (19) with two bearing cups (20) and four screws (21). WARNING CAUTION NOTE Step (11) requires the aid of an assistant. Do not use steel hammers to seat bearing cups in drive yokes. Failure to comply may result in injury to personnel or damage to equipment. Check bearing cups to ensure all needle bearings are in place prior to installation. Replace bearing cups if needle bearings are missing or out of place. Failure to comply may result in damage to equipment. NOTE Wipe end of yoke bearing bores prior to installation. There are two types of bearing cups, those with tabs and those without. Perform the following step on bearing cups not equipped with tabs.