TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download

Page 589 of 1434

TM 9-2320-366-34-2 Change 2 10-33 10-6. INTERMEDIATE AXLE DIFFERENTIAL CARRIER REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-366-10-1). Differential oil drained (TM 9-2320-366-20). Axle shaft removed (TM 9-2320-366-20-4). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Goggles, Industrial (Item 28, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B) Hammer, Hand, Soft Hand (Item 33, Appendix B) Tools and Special Tools (Cont) Lift, Transmission/Differential (Item 39, Appendix B) Sling, Cargo (Item 56, Appendix B) Materials/Parts Sealant, Adhesive (Item 68, Appendix C) Screw, Cap (4) (Item 366.1, Appendix F) Personnel Required (2) a. Removal. (1) Lift tabs from two bearing cups (1) (1.1) Remove four screws (2) and two bearing cups (1) from drive yoke (3). Discard screws. (2) Slide drive shaft (4) from side to side and separate universal joint (5) from drive yoke (3). (3) Attach drive shaft (4) to frame (6). WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. NOTE Step (3) requires the aid of an assistant. NOTE All drive shafts are disconnected the same way. Intermediate drive shaft shown. There are two types of bearing cups, those with tabs and those without. Perform the following step on bearing