TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 583 of 1434
TM 9-2320-366-34-2 Change 2 10-30.1/(10-30.2 Blank) (4) Remove drive yoke nut (7) from pinion shaft (8). Discard drive yoke nut. (5) Place drain pan under pinion shaft (8). (6) Remove drive yoke (3) from pinion shaft (8). (7) Remove yoke seal (9) from drive yoke (3). Discard yoke seal. (8) Remove pinion seal (10) from intermediate differential carrier (11). Discard pinion seal. b. Installation. (1) Apply a small amount of sealing compound to outside edge and spring cavity of pinion seal (1). (2) Install pinion seal (1) in intermediate differential carrier (2). (3) Visually verify pinion seal (1) is properly seated. (4) Install yoke seal (3) on drive yoke (4). (5) Install drive yoke (4) on pinion shaft (5) with drive yoke nut (6). (6) Tighten drive yoke nut (6) to 450-601 lb-ft (610-815 N•m). NOTE Input and output pinion and yoke seals and drive yokes are removed the same way. Input pinion and yoke seals and drive yoke shown. NOTE Vehicles serial number 0001 through 3133, were not originally equipped with yoke seals. Yoke seals may not be present if maintenance has not been previously performed on drive yoke. NOTE Input and output pinion and yoke seals and drive yokes are installed the same way. Input pinion and yoke seals and drive yoke shown.