TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 578 of 1434
TM 9-2320-366-34-2 10-3. REAR AXLE BOGIE REPAIR (CONT) NOTE It may be necessary to raise or lower axles to align holes in housing with spring. (22) Position spring holder (17) on spring (18) with two U- bolts (19), four washers (20), and self-locking nuts (21). (23) Tighten four self-locking nuts (21) to 200 lb-ft (271 N·m), in sequence shown. (24) Re-tighten four self-locking nuts (21), in increments of 50 lb-ft (67 N·m), to 390-510 lb-ft (529-692 N·m) in sequence shown. (25) Fill housing (10) with lubricating gear oil. WARNING Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin and clothing. Keep away from open fire and use in a well- ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately with soap and water. Failure to comply may result in injury to personnel. (26) Apply teflon pipe sealant to threads of bolt (22) and plug (23). (27) Position bolt (22) in housing (10). (28) Tighten bolt (22) to 22-26 lb-ft (30-35 N·m). (29) Install plug (23) in cover (14). (30) Remove trestles from vehicle. 10-26 Change 1