TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 575 of 1434
TM 9-2320-366-34-2 Change 2 10-24.1 (6) Press two bearing races (9) in housing (10). (7) Install housing (10) on shaft (2). (8) Position bearing cone (11) in housing (10). (9) Position mounting plate (12) on shaft (2) with three screws (13). (10) Tighten three screws (13) to 150 lb-ft (203 N•m)). (11) Measure bearing backlash from frame rail (16) to front side of houseing (10). CAUTION CAUTION Use care when installing housing. Seals are easily damaged. Failure to comply may result in damage to equipment. NOTE Rear axle bogie components have very close tolerances. It may be necessary to seat housing on shaft with a deadblow hammer prior to tightening screws. • Acceptable bearing backlash is 0.002-0.012 in. (0.05-0.30 mm). Failure to achieve acceptable bearing backlash may result in damage to equipment. • Housing must rotate by hand without binding. Failure to comply may result in damage to equipment. NOTE • Use two pry bars to move housing on shaft when measuring bearing backlash. • Record bearing backlash measurement.