TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 568 of 1434
TM 9-2320-366-34-2 10-20.2 Change 2 10-2. INTERMEDIATE AXLE ASSEMBLY REPLACEMENT (CONT) (71) Tighten four screws (69). (71.1) Tighten four screws (69) to 26-35 lb-ft (35-47 N•m) (71.2)Fold tabs on four screws (69). (72) Apply lubrication to grease fittings on drive shaft (64). (73) Remove drive shaft (70) from frame (65). (74) Position universal joint (71) on drive yoke (72) with two bearing cups (73) and four screws (74). CAUTION WARNING CAUTION Grease must flow from all four seals. Failure to comply may result in damage to equipment. NOTE Step (73) requires the aid of an assistant. Do not use steel hammers to seat bearing cups in drive yokes. Failure to comply may result in injury to personnel or damage to equipment. Check bearing cups to ensure all needle bearings are in place prior to installation. Replace bearing cups if needle bearings are missing or out of place. Failure to comply may result in damage to equipment. NOTE Wipe end of yoke bearing bores prior to installation. NOTE Perform steps (71.1) and (71.2) on bearing cups equipped with tabs. NOTE • Perform step (71) on kits equipped with shearhead screws. • Alternately tighten screws. • When correct torque is reached, bearing cup small screw hex head will break off.