TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 546 of 1434
TM 9-2320-366-34-2 10-2 Change 2 Section II. MAINTENANCE PROCEDURES 10-2. INTERMEDIATE AXLE ASSEMBLY REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Intermediate axle assembly wheels removed (TM 9- 2320-366-10-2). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Lift, Transmission/Differential (Item 39, Appendix B) Trestle, Motor Vehicle Maintenance (2) (Item 81, Appendix B) Wrench, Torque, 0-600 lb-ft (Item 97, Appendix B) Multiplier, Torque Wrench (Item 42, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B) Wrench Set, Socket (Item 84, Appendix B) Goggles, Industrial (Item 28, Appendix B) Hammer, Hand, Soft Head (Item 33, Appendix B) Tools and Special Tools (Cont) Wrench Set, Crowfoot Ratcheting (TM 9-2320-366- 20) Sling, Cargo (2) (Item 56, Appendix B) Jack, Dolly Type, Hydraulic (Item 37, Appendix B) Materials/Parts Sealing Compound (Item 69, Appendix C) Dispenser, Pressure Sensitive Adhesive Tape (Item 30, Appendix C) Sealing Compound (Item 75, Appendix C) Screw, Self-Locking (8) (Item 366.1, Appendix F) Personnel Required (3) a. Removal. (1) Place vehicle on trestles. (2) Lift tabs from two bearing cups (1). (2.1) Remove four screws (2) and two bearing cups (1) from drive yoke (3). Discard screws. (3) Slide drive shaft (4) from side to side and separate universal joint (5) from drive yoke (3). (4) Attach drive shaft (4) to frame (6). WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. NOTE • Steps (2) through (4) require the aid of an assistant. • All drive shafts are disconnected the same way. Intermediate drive shaft shown. • There are two types of bearing cups, those with tabs and those without. Perform step (2) on bearing cups with tabs.