TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 542 of 1434
TM 9-2320-366-34-2 9-6. STEERING KNUCKLE MECHANISM REPLACEMENT (CONT) NOTE Perform steps (25) through (31) if end play is not between 0.005-0.015 in. (0.0127-0.0381 cm). (25) Use floor jack and raise steering knuckle (3) to apply pressure to access cover (15). (26) Remove screw (13), washer (12), bracket (10), and washer (11) from pivoting arm (4). (27) Remove three screws (8), washers (7), pivoting arm (4), and shim(s) (9) from steering knuckle (3). NOTE Shim(s) are added to decrease end play or removed to increase end play. (28) Remove or add shim(s) (9) to obtain correct end play. (29) Position shim(s) (9) and pivoting arm (4) on steering knuckle (3) with three washers (7), and screws (8). (30) Position bracket (10) on pivoting arm (4) with washer (11), washer (12) and screw (13). (31) Tighten three screws (8) and screw (13) to 500-650 lb-ft (678-881 N·m). (32) Perform steps (20) through (31) to determine if end play is correct. (33) Remove dial indicator from front axle (2). (34) Remove floor jack from steering knuckle (3). 9-28