TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download

Page 541 of 1434

TM 9-2320-366-34-2 (15) Install seal (14) on access cover (15). CAUTION Washer bearing must be positioned with grooves facing up and hole aligned with pin in steering knuckle. (16) Install washer bearing (16) on access cover (15). (17) Position access cover (15) on steering knuckle (3) with four washers (17) and screws (18). (18) Tighten four screws (18) to 500-650 lb-ft (678-881 N·m). (19) Install grease fitting (19) on access cover (15). (20) Install dial indicator on front axle (2) so pointer contacts surface of pivoting arm (4). (21) Use floor jack and raise steering knuckle (3) to apply pressure to access cover (15). (22) Set dial indicator to zero. NOTE End play should read between 0.005-0.015 in. (0.0127-0.0381 cm). (23) Lower floor jack from steering knuckle (3). (24) Read end play on dial indicator. 9-27