TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 536 of 1434
TM 9-2320-366-34-2 9-6. STEERING KNUCKLE MECHANISM REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-366-10-1). Front axle shaft removed (para 9-3). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Goggles, Industrial (Item 28, Appendix B) Gloves, Rubber (Item 26, Appendix B) Indicator, Dial (Item 36, Appendix B) Multiplier, Torque Wrench (Item 42, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B) Wrench, Torque, 0-600 lb-ft (Item 97, Appendix B) Sling, Cargo (Item 56, Appendix B) Tools and Special Tools (Cont) Jack, Dolly Type, Hydraulic (Item 37, Appendix B) Tie Down, Cargo Aircraft (Item 74, Appendix B) Materials/Parts Pin, Cotter (Item 334, Appendix F) (left side) Pin, Cotter (Item 328, Appendix F) (right side) Nut, Self-Locking (Item 202, Appendix F) Seal, Non-metallic (2) (Item 370, Appendix F) Bearing, Washer, Thrust (Item 1, Appendix F) Rag, Wiping (Item 60, Appendix C) Dispenser, Pressure Sensitive Adhesive Tape (Item 30, Appendix C) Personnel Required (2) WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. a. Removal. (1) Remove cotter pin (1), nut (2), and tie rod (3) from steering knuckle (4). Discard cotter pin. 9-22