TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download

Page 534 of 1434

TM 9-2320-366-34-2 9-20.2 Change 2 9-5. FRONT AXLE DIFFERENTIAL PINION SEAL, YOKE SEAL AND DRIVE YOKE REPLACEMENT (CONT) (8) Position universal joint (9) on drive yoke (4) with two bearing cups (10) and four screws (11). (8.1) Tighten four screws (11) to 26-35 lb-ft (35-47 N•m). (9) Tighten four screws (11). WARNING CAUTION Do not use steel hammers to seat bearing cups in drive yokes. Failure to comply may result in injury to personnel or damage to equipment. Check bearing cups to ensure all needle bearings are in place prior to installation. Replace bearing cups if needle bearings are missing or out of place. Failure to comply may result in damage to equipment. NOTE Wipe end of yoke bearing bores prior to installation. There are two types of bearing cups, those with tabs and those without. Perform step (8.1) on bearing cups not equipped with tabs. NOTE Perform step (8.1) on kits equipped with screws P/N C5H5-24-39. NOTE Perform step (9) on kits equipped with shear head screws. Alternately tighten screws. When correct torque is reached, bearing cup screw small hex head will break off.