TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 531 of 1434
TM 9-2320-366-34-2 Change 2 9-19 9-5. FRONT AXLE DIFFERENTIAL PINION SEAL, YOKE SEAL AND DRIVE YOKE REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-366-10-1). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Puller Kit, Universal (Item 51, Appendix B) Wrench Set, Socket, (Item 84, Appendix B) Multiplier, Torque Wrench (Item 42, Appendix B) Driver, Differential Pinion Seal (Item 51, Appendix D) Driver, Front and Rear Differential Yoke Seal (Item 54, Appendix D) Goggles, Industrial (Item 28, Appendix B) Socket Set, Impact (Item 58, Appendix B) Hammer, Hand, Soft Head (Item 33, Appendix B) Tools and Special Tools (Cont) Hammer, Soft Head (Item 33, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B) Sling, Cargo (Item 56, Appendix B) Holding Bar, Pinion (TM 9-2320-366-20) Materials/Parts Sealing Compound (Item 76.3, Appendix C) Seal, Plain Encased (Item 386.1, Appendix F) Nut, Self-Locking (Item 193, Appendix F) Screw, Cap (4) (Item 366.1, Appendix F) Personnel Required (2) a. Removal. (1) Lift tabs from two bearing cups (1) (1.1) Remove four screws (2) and two bearing cups (1) from drive yoke (3). Discard screws. (2) Slide drive shaft (4) from side to side and separate universal joint (5) from drive yoke (3). WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. NOTE There are two types of bearing cups, those with tabs and those without. Perform step (1) on bearing cups with tabs.