TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 530 of 1434
TM 9-2320-366-34-2 9-18 Change 2 9-4. FRONT AXLE DIFFERENTIAL CARRIER REPLACEMENT (CONT) (8.1) Tighten four screws (12) to 26-35 lb-ft (35-47 N•M). (8.2) Fold tabs on four screws (12). (9) Apply lubrication to grease fittings (TM 9-2320-366- 20). c. Follow-On Maintenance. (1) Install front axle shaft (para 9-3). (1.1) Lubricate drive shaft universal joint and slip yoke (TM 9-2320-366-20-1). (2) Refill front axle differential carrier oil (TM 9-2320-366-20). (3) Install tie-rod assembly (TM 9-2320-366-20-4). (4) Start engine (TM 9-2320-366-10). (5) Operate vehicle and check for proper operation of front axle differential carrier (TM 9-2320-366-10-1). (6) Shut down engine (TM 9-2320-366-10). (7) Check front axle differential carrier for oil leaks. End of Task. CAUTION Grease must flow from all four seals. Failure to comply may result in damage to equipment. NOTE Perform the following two steps on bearing cups equipped with tabs.