TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 525 of 1434
TM 9-2320-366-34-2 Change 2 9-15 9-4. FRONT AXLE DIFFERENTIAL CARRIER REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-366-10-1). Cab raised (TM 9-2320-366-10-1). Tie-rod assembly removed (TM 9-2320-366-20-4). Front axle shafts removed (para 9-3). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Goggles, Industrial (Item 28, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B) Tools and Special Tools Lift, Transmission/Differential (Item 39, Appendix B) Sling, Cargo (Item 56, Appendix B) Materials/Parts Sealant, Adhesive (Item 68, Appendix C) Screw, Cap (4) (Item 366.1, Appendix F) Personnel Required (2) a. Removal. (1) Lift tabs from two bearing cups (1). (1.1) Remove four screws (2) and two bearing cups (1) from drive yoke (3). Discard screws. (2) Slide drive shaft (4) from side to side and separate universal joint (5) from drive yoke (3). WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. NOTE There are two types of bearing cups, those with tabs and those without. Perform the following step on bearing cups with tabs.