TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 523 of 1434
TM 9-2320-366-34-2 Change 2 9-13 b. Cleaning/Inspection. (1) Clean all metal parts with dry cleaning solvent and dry using compressed air prior to inspection. NOTE (2) Inspect two bushings (1) and thrust washers (2) in spindle assembly for cracks, pitting, and corrosion. c. Installation. (1) Apply a small amount of grease to outside edges of inner seal (1). (2) Install inner seal (1) on front axle housing (2). (3) Install front axle shaft (3) in front axle housing (2). WARNING CAUTION • Dry Cleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and gloves; use only in well ventilated area; avoid contact with skin, eyes, and clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when using solvent; the flashpoint for Type I Dry Cleaning Solvent is 100°F (38°C) and for Type II is 130°F (50°C). Failure to comply may result in serious injury or death to personnel. • If personnel become dizzy while using cleaning solvent, immediately get fresh air and medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts eyes, immediately flush eyes with water and get immediate medical attention. Failure to comply may result in serious injury or death to personnel. • Compressed air used for cleaning purposes will not exceed 30 psi (207 kPa). Use only with effective chip guarding and personal protective equipment (goggles/shield, gloves, etc). Failure to comply may result in serious injury or death to personnel. Replace any parts that fails visual inspection. Ensure front axle shaft does not damage inner seal. Failure to comply may result in damage to equipment.