TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 518 of 1434
TM 9-2320-366-34-2 9-8.2 Change 2 9-2. FRONT AXLE ASSEMBLY REPLACEMENT (CONT) (14) Tighten four screws (18). (14.1)Tighten four screws (18) to 26-35 lb-ft (35-47 N•m) (14.2)Fold tabs on four screws (18). (15) Connect drag link end (19) to pivoting arm (20). (16) Position nut (21) on drag link end (19). (17) Tighten nut (21) to 140-170 lb-ft (190-230 N•m). (18) Install cotter pin (22) in nut (21). (19) Install clamp (23) on bracket (4) with screw (24) and self-locking nut (25). NOTE Left and right sides of front axle assembly is installed the same way. Right side shown. NOTE Perform the following two steps on bearing cups equipped with tabs. NOTE • Perform the following step on kits equipped with shearhead screws. • Alternately tighten screws. • When correct torque is reached, bearing cap small screw hexhead will break off.