TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 501 of 1434
TM 9-2320-366-34-2 Change 2 8-17 (11) Tighten four screws (15). (11.1)Tighten four screws (15) to 26-35 lb-ft (35-47 N•m). (11.2)Fold tabs on four screws (15). (12) Apply lubrication to grease fittings (1). e. Follow-On Maintenance. Test drive vehicle (TM 9-2320-366-10-1). End of Task. CAUTION NOTE • Perform the following step on kits equipped with shear head screws. • Alternately tighten screws. • When correct torque is reached, bearing cap screw small hex head will break off. Grease must flow from all four seals. Failure to comply may result in damage to equipment. NOTE Perform the following two steps on bearing cups equipped with tabs.