TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 498 of 1434
TM 9-2320-366-34-2 8-16 Change 2 (4) Apply lubrication to grease fittings (1). (5) Position universal joint (2) on transfer case yoke (6) with two bearing cups (7) and four screws (8). (5.1) Tighten four screws (8) to 26-35 lb-ft (35-47 N•m). CAUTION WARNING CAUTION Grease must flow from all four seals. Failure to comply may result in damage to equipment. Do not use steel hammers to seat bearing cups in drive yokes. Failure to comply may result in injury to personnel or damage to equipment. Check bearing cups to ensure all needle bearings are in place prior to installation. Replace bearing cups if needle bearings are missing or out of place. Failure to comply may result in damage to equipment. NOTE • Wipe end of yoke bearing bores prior to installation. • There are two types of bearing cups, those with tabs and those without. Perform the following step on bearing cups not equipped with tabs. NOTE Perform the following step on kits equipped with screws P/N C5H5-24-39.