TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 493 of 1434
TM 9-2320-366-34-2 Change 2 8-11 8-4. M1086/M1089 INTERMEDIATE FRONT DRIVE SHAFT AND COUPLER BEARING REPLACEMENT/REPAIR This task covers: a. Removal b. Disassembly c. Assembly d. Installation e. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-366-10-1). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B) Goggles, Industrial (Item 28, Appendix B) Wrench, Torque, 0-600 lb-ft (Item 97, Appendix B) Press, Arbor, Hand Operated (Item 48, Appendix B) Hammer, Hand, Soft Head (Item 33, Appendix B) Rag, Wiping (Item 60, Appendix C) Materials/Parts Grease, Automotive and Artillery (GAA) (Item 35, Appendix C) Nut, Self-Locking (2) (Item 204, Appendix F) Screw, Cap (12) (Item 366.1, Appendix F) Nut, Self-Locking (Item 196.1, Appendix F) Personnel Required (2) a. Removal. (1) Lift tabs from two bearing cups (1). (1.1) Remove four screws (2) and two bearing cups (1) from intermediate front drive yoke (3). Discard screws. (2) Slide intermediate front drive shaft (4) from side to side and separate universal joint (5) from intermediate front drive yoke (3). WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. NOTE • All drive shafts are disconnected the same way. Intermediate drive shaft shown. • There are two types of bearing cups, those with tabs and those without. Perform the following step on bearing cups with tabs.