TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 491 of 1434
TM 9-2320-366-34-2 Change 2 8-10.1/(8-10-2 Blank) (8) Tighten four screws (11). (8.1) Tighten four screws (11) to 26-35 lb-ft (35-47 N•m). (8.2) Fold tabs on four screws (11). (9) Apply lubrication to grease fittings (TM 9-2320- 366-20). c. Follow-On Maintenance. (1) Check transfer case oil level (TM 9-2320-366-20). (1.1) Lubricate drive shaft universal joint and slip yoke (TM 9-2320-366-20-1). (2) Operate vehicle and check for proper operation of drive train (TM 9-2320-366-10-1). (3) Check seal for oil leaks. End of Task. CAUTION NOTE • Perform the following step on kits equipped with sheared screws. • Alternately tighten screws. • When correct torque is reached, bearing cap small screw hex head will break off. Grease must flow from all four seals. Failure to comply may result in damage to equipment. NOTE Perform the following step on bearing cups equipped with tabs.