TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 489 of 1434
TM 9-2320-366-34-2 Change 2 8-9 (4) Remove self-locking nut (7) and washer (8) from shaft (9). Discard self-locking nut. (5) Remove drive yoke (3) from shaft (9). (6) Remove seal (10) from housing (11). Discard seal. b. Installation. (1) Apply a small amount of sealing compound to outside edge and spring cavity of seal (1). (2) Install seal (1) in housing (2). (3) Visually verify seal (1) is properly seated. (3.1) Apply sealant to both sides of washer (5). (4) Position drive yoke (3) on shaft (4) with washer (5) and self-locking nut (6). (5) Tighten self-locking nut (6) to 450-600 lb-ft (610- 815 N•m). WARNING Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin and clothing. Keep away from open fire and use in a well ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately with soap and water. Failure to comply may result in injury to personnel.