TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 482 of 1434
TM 9-2320-366-34-2 Section II. MAINTENANCE PROCEDURE 8-2. TRANSFER CASE CONTROL VALVE ASSEMBLY REPLACEMENT/REPAIR This task covers: a. Removal b. Disassembly c. Cleaning/Inspection d. Assembly e. Installation f. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-366-10-1). Batteries disconnected (TM 9-2320-366-20-3). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B) Wrench, Torque, 0-150 lb-in (Item 91, Appendix B) Goggles, Industrial (Item 28, Appendix B) Gloves, Rubber (Item 26, Appendix B) Multimeter, Digital (Item 41, Appendix B) Wrench Set, Socket (Item 85, Appendix B) Materials/Parts Gasket (Item 68, Appendix F) Gasket (Item 71, Appendix F) Filter Element (Item 32, Appendix F) Packing Preformed (Item 298, Appendix F) Packing Preformed (Item 300, Appendix F) Rag, Wiping (Item 60, Appendix C) Dispenser, Pressure Sensitive Adhesive Tape (Item 30, Appendix C) Solvent, Dry Cleaning (Item 83, Appendix C) WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. a. Removal. (1) Remove 10 bolts (1), valve body cover (2), and gasket (3) from transfer case module (4). Discard gasket. 8-2 Change 1