TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 470 of 1434
TM 9-2320-366-34-2 7-124 Change 2 7-18. TRANSMISSION ASSEMBLY REPLACEMENT (UNUSUAL CONDITIONS) (CONT) (3) Position pressure plate assembly (4) on transmission (2) with 20 bolts (5). (4) Tighten 20 bolts (5) to 25-29 lb-ft (34-39 N • m). (5) Apply light coat of sealing compound to seating surface (6) on transmission (2). (6) Install gasket (7) on transmission (2). (7) Remove five bolts (8) from adapter housing module (9). (8) Position transmission lifting bracket on adapter housing module (9) with five bolts (8). (9) Tighten five bolts (8) to 42-50 lb-ft (57-68 N • m). WARNING NOTE Perform steps (3) and (4) if pressure plate assembly was removed from transmission serial numbers prior to 6510032369. Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin and clothing. Keep away from open fire and use in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately with soap and water. Failure to comply may result in injury to personnel. NOTE Transmission lifting bracket is installed with lift top-dead center facing forward.