TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 447 of 1434
TM 9-2320-366-34-2 7-17. ENGINE AND TRANSMISSION MOUNT BRACKET REPLACEMENT This task covers: a. LH Removal b. LH Installation c. RH Removal d. RH Installation e. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-366-10-1). Hydraulic tank supply and return valves closed (TM 9- 2320-366-10-2) (M1089). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Goggles, Industrial (Item 28, Appendix B) Wrench, Torque, 0-600 lb-ft (Item 97, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B) Wrench Set, Socket (Item 84, Appendix B) Pan, Drain (Item 24, Appendix C) (M1089) Tools and Special Tools (Cont) Jack, Dolly Type, Hydraulic (Item 37, Appendix B) 4x4x8 in. (20 cm) wooden piece Materials/Parts Nut, Self-locking (2) (Item 173, Appendix F) Sealant, Pipe (Item 68.1, Appendix C) Personnel (2) WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. a. LH Removal. NOTE Hydraulic jack is used to support engine and transmission while LH engine and transmission mount bracket is being replaced. (1) Position hydraulic jack with 8 in. (20 cm) wooden block under transmission control valve module (1). (2) Raise hydraulic jack to apply pressure to transmission (2). Change 1 7-101