TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 431 of 1434
TM 9-2320-366-34-2 (12) Remove retaining pin (34), stop (35), spring (36), and control main valve (37) from main valve body (2). (13) Remove two bolts (38) and turbine speed sensor (39) from main valve body (2). b. Cleaning/Inspection. WARNING • Dry Cleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and gloves; use only in well-ventilated area; avoid contact with skin, eyes, and clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when using solvent; the flashpoint for Type I Dry Cleaning Solvent is 100°F (38°C) and for Type II is 130°F (50°C). Failure to comply may result in serious injury or death to personnel. • If personnel become dizzy while using cleaning solvent, immediately get fresh air and medical help. If dry cleaning solvent contacts skin or clothes, flush with cold water. If dry cleaning solvent contacts eyes, immediately flush eyes with water and get immediate medical attention. Failure to comply may result in serious injury or death to personnel. (1) Clean all metal parts with dry cleaning solvent. NOTE Replace any part that fails to pass visual inspection or size measurement requirements. (2) Inspect solenoid (1) for cracks or varnish buildup. (3) Perform solenoid (1) resistance check; resistance should read between 2.0-5.0 ohm on a 10 ohm scale. (4) Inspect C2 latch valve (2) for nicks, scratches, varnish buildup, and free movement in the bore. 7-85