TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 415 of 1434
TM 9-2320-366-34-2 7-10. CONTROL VALVE MODULE REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-366-10-1). Front drive shaft removed (TM 9-2320-366-20-4). Transmission oil filters removed (TM 9-2320-366-20- 4). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B) Wrench, Torque, 0-150 lb-in. (Item 91, Appendix B) Jack, Dolly Type, Hydraulic (Item 37, Appendix B) Goggles, Industrial (Item 28, Appendix B) Tools/Special Tools (Cont) Wrench Set, Socket (Item 85, Appendix B) Materials/Parts Screw, Cap, Hex Head (3) (M10x1.5x55) (Item 77, Appendix C) Nut, Self-Locking (2) (Item 173, Appendix F) Seal (Item 376, Appendix F) Gasket (Item 64, Appendix F) Lubricating Oil, Gear (Item 50, Appendix C) Personnel Required (2) WARNING • Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. • Ensure exhaust system is cool before performing maintenance. Failure to comply may result in injury to personnel. a. Removal. (1) Remove self-locking nut (1) from clamp (2). Discard self-locking nut. (2) Disconnect lower exhaust pipe (3) from muffler (4). (3) Remove clamp (2) from lower exhaust pipe (3). Change 1 7-69