TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 413 of 1434
TM 9-2320-366-34-2 (5) Inspect spring (4) for cracks, burrs, grooves, distortion, scoring, excessive wear or varnish buildup. (6) Inspect regulator valve (5) for cracks, burrs, grooves, distortion, scoring, excessive wear or varnish buildup. (7) Inspect two solenoids (6) for cracks, burrs, grooves, distortion, scoring, excessive wear or varnish buildup. (8) Measure resistance of two solenoids (6), resistance should be between 2.0 - 5.0 ohms. d. Assembly WARNING Use care when installing valve body parts retained by retaining pins. Valve body parts are under tension and can act as projectiles when released. Failure to comply may result in injury to personnel. CAUTION Retaining pins must be installed from the bottom. Failure to comply may result in damage to equipment. (1) Install preformed packings (1 and 2) on C6 interlock valve solenoid (3). (2) Install spring (4), C6 interlock valve (5) and C6 interlock valve solenoid (3) in C6 clutch valve body (6) with retaining pin (7). 7-67