TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 408 of 1434
TM 9-2320-366-34-2 7-8. ROTATING CLUTCH SOLENOID ASSEMBLY REPLACEMENT/REPAIR (CONT) d. Assembly. (1) Install preformed packings (1 and 2) on solenoid (3). WARNING Use care when installing springs. Springs are under tension and can act as projectiles when released. Failure to comply may result in injury to personnel. CAUTION Retaining pins are installed from bottom of solenoid body. Failure to comply may result in damage to equipment. (2) Install spring (4), regulator valve (5), and solenoid (3) in rotating clutch valve body (6) with retaining pin (7). (3) Perform steps (1) and (2) on remaining two solenoids (3). (4) Install preformed packing (8) on pressure switch (9). (5) Position pressure switch (9) on rotating clutch valve body (6) with two screws (10). (6) Tighten two screws (10) to 48-72 lb-in. (5-8 N·m). 7-62