TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 296 of 1434
TM 9-2320-366-34-2 6-5. TRANSMISSION TURBINE SPEED SENSOR REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Control valve module removed (para 7-10). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Wrench, Torque, 0-150 lb-in. (Item 91, Appendix B) Wrench Set, Socket (Item 85, Appendix B) Tools and Special Tools (Cont) Multimeter, Digital (Item 41, Appendix B) Goggles, Industrial (Item 28, Appendix B) Gloves, Rubber (Item 26, Appendix B) Materials/Parts Rag, Wiping (Item 60, Appendix C) Solvent, Dry Cleaning (Item 83, Appendix C) a. Removal. (1) Disconnect wiring harness connector (1) from turbine speed sensor (2). (2) Remove two screws (3) and turbine speed sensor (2) from control valve module (4). b. Installation. NOTE Handle parts carefully to prevent damage. (1) Position turbine speed sensor (2) on control valve module (4) with two screws (3). (2) Tighten two screws (3) to 108-120 lb-in. (12-14 N·m). (3) Connect wiring harness connector (1) to turbine speed sensor (2). c. Follow-On Maintenance. Install control valve module (para 7-10). End of Task. 6-32