TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download

Page 289 of 1434

TM 9-2320-366-34-2 (27) Install preformed packing (40) on shift housing (25). CAUTION Drive and two washers must be aligned with armature shaft during assembly of shift and drive housings. Failure to comply may result in damage to equipment. (28) Position shift housing (25) on drive housing (10) with matchmarks aligned. WARNING Adhesive Sealant MIL-S-46163 can damage your eyes. Wear safety goggles when using; avoid contact with eyes. If sealant contacts eyes, flush eyes with water and get immediate medical attention. Failure to comply may result in injury to personnel. (29) Apply sealing compound to threads of five screws (41). (30) Position five lockwashers (42) and screws (41) in shift housing (25). (31) Tighten five screws (41) to 108-132 lb-in. (12-15 N·m). (32) Install boot (43) on link spool (44). CAUTION Use care not to damage link spool during installation. Failure to comply will result in damage to equipment. (33) Wrap three layers of abrasive cloth around plunger (45) and link spool (44). (34) Position boot (43) and link spool (44) in plunger (45). (35) Hold plunger (45) in a fixed position. (36) Tighten link spool (44) to 27-33 lb-in. (3-4 N·m). 6-25