TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 261 of 1434
TM 9-2320-366-34-2 c. Assembly. NOTE Lubricate all grease seals, front and rear spring caps, seals, and preformed packings prior to installation. (1) Install grease seal (1) in clutch housing (2). CAUTION Ensure piston bearing is packed thoroughly with grease. Failure to comply may result in damage to equipment. (1.1) Pack piston bearing (2.1) thoroughly with grease. WARNING Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin and clothing. Keep away from open fire and use in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately with soap and water. Failure to comply may result in injury to personnel. (1.2) Apply sealing compound to bearing surface of shaft (3). (2) Install shaft (3) in shaft mount (4). WARNING Use care when installing retaining rings. Retaining rings are under tension and can act as projectiles when released. Failure to comply may result in injury to personnel. (3) Install retaining ring (5) in shaft mount (4). Change 1 5-7