TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 240 of 1434
TM 9-2320-366-34-2 4-7. FUEL CONTROL LINKAGE REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-366-10-1). Rocker arm assemblies removed (para 3-12). Tools and Special Tools Tool Kit, Intl. Comb. Eng. (TM 9-2320-366-20) Wrench, Torque, 0-150 lb-in. (Item 91, Appendix B) Tools and Special Tools (Cont) Adapter, Socket Wrench, (Item 3, Appendix B) Socket Wrench Attachment, Screwdriver (TM 9-2320- 366-20) Hammer, Hand Soft Head (Item 33, Appendix B) Tool Kit, Genl Mech (Item 78, Appendix B) Wrench Set, Socket (Item 85, Appendix B) Materials/Parts Lubricating Oil, Engine (Item 47, Appendix C) a. Removal. (1) Remove clip (1) from adapter sleeve (2). CAUTION Do not use hard-jawed pliers or screwdriver to move sleeve. Failure to comply may result in damage to equipment. (2) Slide adapter sleeve (2) in cylinder head (3). WARNING Use care when removing retaining rings. Retaining rings are under tension and can act as projectiles when released. Failure to comply may result in injury to personnel. (3) Remove retaining ring (4) and clevis pin (5) from governor linkage (6). 4-32