TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 166 of 1434
TM 9-2320-366-34-2 3-13. CAM ROLLER FOLLOWERS REPLACEMENT (CONT) (4) Remove plug (8) from top of oil manifold (9). NOTE Perform steps (5) through (7) on center side cover. (5) Remove screw (10), washer (11), and sleeve (12) from center side cover (7). (6) Remove seven screws (13) and washers (14) from center side cover (7). (7) Remove center side cover (7) and gasket (15) from cylinder block (16). Discard gasket. (8) Remove eight screws (17) and washers (18) from front and rear side covers (19 and 20). (9) Remove front and rear side covers (19 and 20) and two gaskets (21) from cylinder block (16). Discard gaskets. b. Disassembly. (1) Remove four screws (1), two sleeves (2), and shaft (3) from side cover (4). NOTE Tag lifter roller followers and injector roller followers prior to removal. (2) Remove two lifter roller followers (5) and injector roller follower (6) from shaft (3). (3) Remove two lifter roller followers (5) and injector roller follower (6) from other side of shaft (3). (4) Perform steps (1) through (3) on two remaining side covers. 3-96