TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 155 of 1434
TM 9-2320-366-34-2 Change 2 3-87 3-11. FLYWHEEL HOUSING REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Starting motor removed (TM 9-2320-366-20-3). Engine speed sensor removed (TM 9-2320-366-20- 3). Engine removed (para 3-3). Flexplate removed (para 3-10). Crankshaft rear seal removed (para 3-9). Oil pan removed (para 3-16). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B) Materials/Parts Gasket Maker (Item 34.1, Appendix C) Screw, Self-Locking (10) (Item 368.1, Appendix F) Personnel Required (2) a. Removal. (1) Remove bolt (1) from flywheel housing (2). (2) Remove two bolts (3) from flywheel housing (2). (3) Remove 10 self-locking screws (4) and flywheel housing (2) from engine (5). Discard self-locking screws. WARNING Flywheel housing weighs approximately 75 lbs (34 kgs). Attach a suitable lifting device prior to removal. Failure to comply may result in injury to personnel or damage to equipment. NOTE Step (3) requires the aid of an assistant.