TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 151 of 1434
TM 9-2320-366-34-2 CAUTION Rear crankshaft seal and sleeve ring are installed with bevel edge toward engine. Failure to comply may result in damage to equipment. (2) Position rear seal (2) in sleeve ring. (3) Position sleeve ring on rear locator. (4) Position installer on rear locator with nut. (5) Tighten nut on installer. (6) Remove nut, installer and sleeve ring from rear locator. (7) Rotate sleeve ring 180 degrees. (8) Position sleeve ring on rear locator. (9) Position installer on rear locator with nut. (10) Tighten nut on installer. (11) Remove nut, installer, and sleeve ring from rear locator. CAUTION Ensure rear seal and wear ring are flush. Failure to comply may result in damage to equipment. (12) Remove two screws and rear locator from crankshaft (1). d. Follow-On Maintenance. (1) Install flexplate (para 3-10). (2) Install engine (para 3-3). End of Task. Change 1 3-83