TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 149 of 1434
TM 9-2320-366-34-2 3-9. CRANKSHAFT REAR SEAL REPLACEMENT This task covers: a. Removal b. Cleaning/Inspection c. Installation d. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine removed (para 3-3). Flexplate removed (para 3-10). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Drill, Portable, Electric (Item 21, Appendix B) Drill Set, Twist (Item 20, Appendix B) Goggles, Industrial (Item 28, Appendix B) Inserter, Seal (Item 36, Appendix B, TM 9-2320-366-20) Tools and Special Tools (Cont) Puller Kit, Universal (Item 40, Appendix B,TM 9-2320-366-20) Wrench Set, Socket, (Item 84, Appendix B) Gloves, Rubber (Item 26, Appendix B) Tool, Distorter (Item 77, Appendix B, TM 9- 2320-366-20) Materials/Parts Seal, Plain Encased (Item 388, Appendix F) Solvent, Dry Cleaning (Item 83, Appendix C) Rag, Wiping (Item 60, Appendix C) a. Removal. WARNING Wear appropriate eye protection when drilling holes. Failure to comply may result in injury to personnel. (1) Drill three evenly spaced holes in seal (1). (2) Remove seal (1) from crankshaft (2). Discard seal. NOTE If crankshaft rear seal has not previously been replaced, a wear ring will not be installed. (3) Remove wear ring (3) from crankshaft (2). Change 1 3-81