TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download

Page 123 of 1434

TM 9-2320-366-34-2 NOTE Measure wires from body of start and charging cable assembly. (149.5) Cut wire (198) to 3 in. (76 mm) in length. (149.6) Cut wire (199) to 4 in. (102 mm) in length. (149.7) Remove 0.38 in. (10 mm) of insulation from wires (198 and 199). (149.8) Cut insulation sleeving (201) to 1.5 in. (38 mm). (149.9) Position insulation sleeving (201) on wire (199). (149.10) Install conductor splice (202) on wires (198 and 199). (149.11) Install insulation sleeving (201) on conductor splice (202). NOTE Install electrical tape as required. (150) Install convoluted tubing (197) on wires (198 and 199). (151) Deleted. (152) Remove nut (202.1) from starting motor terminal (202.2). (153) Position terminal lug TL53 (202.3), ground strap (202.4), terminal lugs TL46 (202.5), and TL25 (202.6) on starting motor terminal (202.2) with nut (202.1). (154) Tighten nut (202.1) to 33-37 lb-ft (45-50 N·m). WARNING Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin and clothing. Keep away from open fire and use in a well- ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately with soap and water. Failure to comply may result in injury to personnel. (155) Apply adhesive on terminal lug TL53 (202.3), ground strap (202.4), terminal lugs TL46 (202.5), TL25 (202.6), nut (202.1) and starting motor terminal (202.2). Change 1 3-55