TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 1153 of 1434
TM 9-2320-366-34-2 14-10. STABILIZER MOUNTING BRACKET REPLACEMENT This task covers: a. Removal b. Inspection c. Installation d. Follow-On Maintenance INITIAL SETUP Equipment Conditions Rear stabilizer bar removed (TM 9-2320-366-20-4). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Goggles, Industrial (Item 28, Appendix B) Wrench, Impact, Electric (Item 88, Appendix B) Socket Set, Impact (Item 58, Appendix B) Press, Arbor (Item 48, Appendix B) Tools and Special Tools (Cont) Wrench, Torque, 0-600 lb-ft (Item 97, Appendix B) Wrench Set, Socket (Item 84, Appendix B) Materials/Parts Bolt (3) (Item 4, Appendix F) Nut, Self-Locking (3) (Item 222, Appendix F) Grease, Automotive and Artillery (GAA) (Item 36, Appendix C) WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. a. Removal. CAUTION When removing bolts, continuous removal of collars is mandatory. Failure to comply will result in seizing of collar to bolt. NOTE Left and right side stabilizer mounting brackets are removed the same way. Right side shown. (1) Remove three collars (1), bolts (2), and mounting bracket (3) from frame (4). Discard collars and bolts. Change 1 14-49