TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 1102 of 1434
TM 9-2320-366-34-2 14-2 Change 2 Section II. MAINTENANCE PROCEDURES 14-2. FRONT LEAF SPRING REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-366-10-1). Front drive shaft removed (left side) (TM 9-2320-366- 20-4). Gravel deflector and gravel deflector extension removed (TM 9-2320-366-20-4). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B) Wrench, Torque, 0-200 lb-in. (Item 93, Appendix B) Wrench, Torque, 0-600 lb-ft (Item 97, Appendix B) Jack, Dolly Type, Hydraulic (Item 37, Appendix B) Tools and Special Tools (Cont) Trestles, Motor Vehicle Maintenance (2) (Item 81, Appendix B) Goggles, Industrial (Item 28, Appendix B) Wrench Set, Socket (Item 84, Appendix B) Socket, Left Front Leaf Spring U-Bolt (Item 11, Appendix D) Materials/Parts Nut, Self-Locking (4) (Item 215, Appendix F) Pin, Cotter (Item 374, Appendix F) Nut, Self-Locking (2) (Item 235, Appendix F) Grease, Automotive and Artillery (Item 34, Appendix C) U-bolt (2) (Item 20.3, Appendix F) Personnel Required (2) a. Removal. (1) Deleted (2) Deleted (3) Remove wheel on side that leaf spring is being removed (TM 9-2320-366-10-1). WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. NOTE Vehicles S/N 11,438 through 13,302 were originally equipped with three leaf springs. When replacing a three leaf spring with a four leaf spring, both sides must be replaced.