TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 1097 of 1434
TM 9-2320-366-34-2 Change 2 13-437 (5) Cut two plastic edges (8) to approximately 9 in. (23 cm). (6) Apply adhesive to plastic edge (8). (7) Install plastic edge (8) on support bracket (9). (8) Position support bracket (9) on vehicle with two bolts (10) and self-locking nuts (11). (9) Tighten two self-locking nuts (11) to 120-147 lb-ft (264-324 N•m). (10) Perform steps (8) and (9) on remaining support bracket. WARNING Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin and clothing. Keep away from open fire and use in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately with soap and water. Failure to comply may result in injury to personnel. NOTE Both support brackets are installed the same way. One support bracket shown.