TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 1082 of 1434
TM 9-2320-366-34-2 13-47. V-ROD CONTROL ARM REPLACEMENT (CONT) d. Rear Installation. (1) Position bolt (1) in support (2). (2) With matchmarks aligned, position support (2) on V-rod control arm (3) with self-locking nut (4). (3) Tighten self-locking nut (4) to 590-736 lb-ft (800-1000 N·m). (4) Remove V-rod control arm (3) from vise. NOTE Step (5) requires the aid of an assistant. (5) Position V-rod control arm (3) on vehicle. WARNING Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately with soap and water. Failure to comply may result in injury to personnel. NOTE Left and right upper end of V-rod control arm are installed the same way. Left side shown. (6) Apply sealant to threads of two bolts (5). (7) Position two bolts (5) in V-rod control arm (3). (8) Perform steps (6) and (7) on right side. 13-422 Change 1