TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 1079 of 1434
TM 9-2320-366-34-2 NOTE Step (5) requires the aid of an assistant. (5) Position V-rod control arm (3) on vehicle. WARNING Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately with soap and water. Failure to comply may result in injury to personnel. NOTE Left and right upper end of V-rod control arm are installed the same way. Left side shown. (6) Apply sealant to threads of two bolts (5). (7) Position two bolts (5) in V-rod control arm (3). (8) Perform steps (6) and (7) on right side. WARNING Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately with soap and water. Failure to comply may result in injury to personnel. (9) Apply sealant to threads of two bolts (6 and 1). CAUTION Do not use pneumatic wrench to install bolts. Thread damage will occur. Failure to comply may result in damage to equipment. (10) Position two bolts (6) in support. (11) Tighten two bolts (6 and 1) and four bolts (5) to 398-486 lb-ft (540-660 N·m). Change 1 13-419