TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 1076 of 1434
TM 9-2320-366-34-2 13-47. V-ROD CONTROL ARM REPLACEMENT This task covers: a. Front Removal b. Front Installation c. Rear Removal d. Rear Installation e. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-366-10-1). Driveshaft removed (TM 9-2320-366-20-4). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Goggles, Industrial (Item 28, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B) Multiplier, Torque Wrench (Item 42, Appendix B) Wrench, Torque, 0-600 lb-ft (Item 60, Appendix C) Socket, Socket Wrench (Item 72.1, TM 9-2320-366-20 Appendix B) Materials/Parts Antiseize Compound (Item 12, Appendix C) Nut, Self-Locking (Item 220, Appendix F) WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. a. Front Removal. CAUTION Do not use a pneumatic wrench to remove nuts, bolts from V-rod. Thread damage will occur. Failure to comply may result in damage to equipment. NOTE Intermediate and rear axle quick release valve brackets are removed the same way. Intermediate axle quick release valve bracket shown. (1) Remove four nuts (1), washers (2), spacers (3), two U- bolts (4), and bracket (5) from V-rod control arm (6). (2) Position bracket (5) to allow access. 13-416 Change 1