TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 1074 of 1434
TM 9-2320-366-34-2 13-46. M1088 FIFTH WHEEL ASSEMBLY REPLACEMENT/REPAIR (CONT) m. Sliding Mechanism Assembly. (1) Position top plate stopper (1) on fifth wheel assembly (2) with eight washers (3), four bolts (4), and self-locking nuts (5). (2) Tighten four self-locking nuts (5) to 170 lb-ft (231 N·m). WARNING Use care when removing springs. Springs are under tension and can act as projectiles when released. Failure to comply may result in injury to personnel. NOTE • Left and right side plungers are installed the same way. Left side shown. • Springs must be compressed to access pivot pins. (3) Position plunger (6) in sliding mechanism (7). (4) Position stop nut (8) on adjusting screw (9). (5) Position adjusting screw (9) in plunger (6). (6) Position stop (10), spring (11), and retainer (12) on plunger (6). 13-414