TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 101 of 1434
TM 9-2320-366-34-2 NOTE Left and right side resilient mounts are installed the same way. Right side shown. (27) Position resilient mount (37) on engine mount bracket (38) with two screws (39) and self-locking nuts (40). (28) Position sleeve (41), washer (42), and bolt (43) in resilient mount (37). (29) Perform steps (27) and (28) on left side resilient mount. WARNING Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin and clothing. Keep away from open fire and use in a well- ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately with soap and water. Failure to comply may result in injury to personnel. (29.1) Apply light coat of sealing compound to seating surface (43.1) on transmission (43.2). (29.2) Install gasket (43.3) on transmission (43.2). WARNING Engine weighs approximately 1500 lbs (681 kgs). Attach a suitable lifting device prior to installation. Failure to comply may result in injury to personnel or damage to equipment. NOTE Hoist assembly is required until front and rear mounting bolts are installed. (30) Position engine (44) in vehicle. (31) Apply sealing compound to threads of two bolts (45). (32) Position two bolts (45) in right rear mounting bracket (46). Change 1 3-39