TM-9-2320-366-34-1 MTV Direct Maintenance Manual M1083 Series - Volume 1 Download

Page 878 of 1591

Change 1 2-733 TM 9-2320-366-34-1 CONTINUITY TEST (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to internal wiring harness feed-through connector pin C2. (3) Connect negative (-) probe of multimeter to internal wiring harness connector C pin B and note reading on multimeter. (4) If continuity is not present, replace transmission internal wiring harness (para 7-13). (5) Connect positive (+) probe of multimeter to transmission feed through connector pin C2. (6) Connect negative (-) probe of multimeter to all other pins of transmission feed- through connector and note reading on multimeter. (7) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (8) If continuity is present, transmission internal wiring harness is shorted, replace transmission internal wiring harness (para 7-13).